QCI0150 REV. 0
Page 8 of 14
Certified 06/04/10
8
7
Check the size of the Header [1]. It should be equal to the opening size
minus 1 1/2”(+/- 1/8” tolerance). Slide the Wall Mount Header Brackets [7]
on both ends of the Header [1], align the Header with the inner part of the
Header Brackets [7] mounted to the walls and slide out the Wall Mount
Header Brackets [7] (see pictures). Rotate the Wall Mount Header Brackets,
the set screws should be facing up and inside the shower .Then tighten the
4 set screws on each Wall Mount Header Bracket.
Note: The set screws closest to the wall must be tightened first.
Disassemble two Wall Mount Header Brackets [7]
by loosening the set screws. Next, put the supplied large wall
plugs into the holes that were drilled in the walls in step 2.
Screw the inner part of the Header Bracket [7] into the wall
with the supplied socket countersunk head screw.
WALL PLUG
SOCKET HEAD
SCREW
WALL MOUNT HEADER
BRACKET INSERT
WALL
U-CHANNEL
Loosen all 4 set screws
but do not remove them
1.
2.
View from Inside Shower
View from Outside Shower
WALL MOUNT HEADER
BRACKET
Panel Side
HEADER
WALL MOUNT HEADER
BRACKET