QCI0150 REV. 0
Page 11 of 14
Certified 06/04/10
13
Mount the Roller Assembly With Stopper Pin [9] to the wall side
of the Door Panel with the bolts facing to the outside of the shower.
Mount the Roller Assembly [10] to the stationary panel side of the Door
Panel with the bolts facing to the outside of the shower.
1"
14
ROLLER ASSEMBLY
WITH STOPPER PIN
ROLLER ASSEMBLY
Wall Side
Stationary
Panel side
MOUNT BOLT
Cut the Drip Vinyl [5] to the appropriate size. It should be equal to the
Door Width minus 1”.
Place the Drip Vinyl [5] onto the bottom of the door panel. Line it up on the wall side of the door.
INSIDE
DRIP VINYL
WALL SIDE
DOOR PANEL
DOOR PANEL
15
Carefully hang the Door Panel with Rollers [9/10] on the
Header [1]. Make sure the Door Panel is lined up inside the
Guide [11]. Then, if necessary adjust the Door Panel so the top
of the glass is flush with the Stationary Panel by loosening
the set screw located on the top of the Roller Assembly
with 4mm Allen wrench and rotating the cam shaft.
(See next page for illustration.)
DRIP VINYL
DOOR PANEL
STATIONARY
PANEL
DOOR PANEL
STATIONARY
PANEL
GUIDE
Allen Wrench
from Guide can
be use
4mm ALLEN
WRENCH
SET SCREW
TIP: Run a small bead of silicone on the
interior where the drip vinyl and the glass
meet to secure the vinyl sweep and prevent
water from collecting inside the sweep.
Tip: a small screwdriver or Allen wrench
can be used to rotate the cam shaft.
View from Inside Shower
