roco Z21 WLANmaus, Manual

Page: 58 / 104

Model Railway Control Unit
58
CV Description Range Default
#211 DCC
basic
/DCC
ext
mapping for 1R, Signal 1
This CV can be used to set which signal aspect should be displayed after a DCCbasic swit -
ching command “1 Red” on signal 1.
255 = Specification in accordance with signal configuration
The DCC
basic
switching commands display the signal aspects as predefined in the signal
configuration of the signal decoder selected via CV #41.
0 … 254 =
Explicit specification through user
If you wish to avoid specifications in the selected signal configuration, then you can enter
the DCC
ext
value here which accords with the required signal aspect. An explicit specifi -
cation by the user may be expedient if, for example, the DCC system used does not yet
handle any DCC
ext
switching commands, and/or any switching sequences already available
for signals deviate substantially from those in the Z21 signal DECODER. In this case, the
Z21 signal DECODER can be adapted highly flexibly to the existing system.
Example: CV #211 = 16 (“Clear to proceed”) … Signal 1 then displays, after a DCC
basic
switching command “1 Red” the signal aspect “Clear to proceed to”.
You can also find the valid DCC
ext
value range as well as the predefined assignment for the
DCC basic switching commands of your signal in Appendix A – Signal configuration “Uni -
versal” or under the link provided in Appendix B – Signal configurations .
For explanations on the DCC
basic
and DCC
ext
switching commands, see also the section
Operation on DCC control centres.
Factory setting: Specification in accordance with signal configuration
0 - 255 255
#212 DCC
basic
/DCC
ext
mapping for 1G, Signal 1
Corresponding with CV#211 for the DCC
basic
switching command “1 Green” .
0 - 255 255
#213 DCC
basic
/DCC
ext
mapping for 2R, Signal 1
Corresponding with CV#211 for the DCC
basic
switching command “2 Red” .
0 - 255 255
#214 DCC
basic
/DCC
ext
mapping for 2G, Signal 1
Corresponding with CV#211 for the DCC
basic
switching command “2 Green” .
0 - 255 255
#221
to
#224
DCC
basic
/DCC
ext
mapping for Signal 2
Corresponding with CV #211 to #214 for the signal 2.
0 - 255 255
#231
to
#234
DCC
basic
/DCC
ext
mapping for
Signal 3
Corresponding with CV #211 to #214 for the signal 3.
0 - 255 255
#241
to
#244
DCC
basic
/DCC
ext
mapping for Signal 4
Corresponding with CV #211 to #214 for the signal 4.
0 - 255 255
#250 Decoder type
37 = ROCO 10837 Z21 signal DECODER
read only 37
6.4 Resetting to factory status
If you want to set all settings back to the original status condition, keep the programming button held down until all LEDs are lit and
the blue LED is flashing. This means that all settings are reset and the reset has been initiated.
Alternatively, the value 8 can be written back to CV#8.