WWW.Z21.EU
Model Railway Control Unit
42
6.3 Resetting to factory status
If you want to set all settings back to the original status condition, keep the programming button held down until all LEDs are lit and
the blue LED is flashing. This means that all settings are reset and the reset has been initiated.
Alternatively, the value 8 can be written back to CV#8.
7. Meaning of the LEDs
Normal operation
Colour
Status
Meaning
Blue (status)
on
Track signal present on input DCC.
Blue (status)
flashes
No track signal present on input DCC.
(The decoder still also accepts switching commands from
the zLink interface.)
Red (Error)
flashes
Short circuit or overload detected.
Green (Data)
aus
“ROCO” addressing mode.
Green (Data)
on
“RCN-213” addressing mode.
Green (Data)
flashes briefly
Decoder processes data/commands from the track or from
the zLink interface.
Blue
Red
Green
White
flashes
on
on
on
Resetting to factory status.
(Hold down programming button for longer than 8s.)
Colour
Status
Meaning
Green
White
on
flashes 1 x white
(short, pause)
Option 1: Program addresses for outputs 1 to 8. Decoder
waits for switch command, or long button press for next op
-
tion.
Red
White
on
flashes 2 x white
(short, short, pause)
Option 2: Program address for outputs 5 to 8. Decoder waits
for switch command, or long button press for next option.
Red
White
on
flashes 3 x white
(short, short, short, pause)
Option 3: “ROCO” addressing mode.
• Press the programming button briefly: Change over mode
• Press the programming button for a long time: save
Green
White
on
flashes 3 x white
(short, short, short, pause)
“ROCO” addressing mode.
Blue
White
flashes
flashes
Next option
(When pressing the programming button for a long time)
After last option: Save setting and return to normal opera
-
tion.
Configuration mode
(button programming)