background image

To order parts and supplies: 800.343.9353  >>  eastwood.com 

3

 

 READ INSTRUCTIONS 

•  Thoroughly read and understand these product instructions before using 

this tool. Failure to follow all warnings can result in tool damage or serious 
physical injury.

•  Keep these product instructions for future reference.

 

RESPIRATORY HAZARD!

•  Dust and fine particulate matter is generated during the sanding process 

which can contain toxic substances such as lead, silica, solvents and oth-
ers. Breathing this dust and fine particulate matter can cause many serious 
respiratory health conditions. Always use NIOSH approved respiratory 
protection while using this Sander.

 

EYE INJURY HAZARD!

•  Rapidly moving abrasive surfaces can eject metal particles, dirt and debris 

at high velocity. Always wear ANSI approved eye protection when operating 
this tool.

 

HEARING DAMAGE HAZARD!

•  This tool emits high sound levels while operating. Use ANSI approved ear 

protection when operating.

 

DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury.

 

WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.

 

CAUTION used with the safety alert symbol, indicates a hazardous situation which, if not avoided, 
could result in minor or moderate injury.

 

NOTICE is used to address practices not related to personal injury.

SAFETY INFORMATION

The following explanations are displayed in this manual, on the labeling, and on all other information 
provided with this product:

Summary of Contents for 31873









Reviews: