Rockwell ShopSeries RS8137, Manual

Page: 14 / 16

2400PSI PETROL HIGH PRESSURE WASHER EN
14
materials, such as dirt, etc. To correct the problem,
immediately clean the spray nozzle following these
instructions:
1) Switch engine off and turn off water supply
2) ALWAYS point spray gun in a safe direction, lock
the gun and squeeze spray gun trigger to release
retained high water pressure.
3) Remove nozzle from end of nozzle extension.
4) Use a small paper clip to free any foreign material
clogging or restricting nozzle.
4. ENGINE MAINTENANCE
Spark plug (See Fig. E1, E2)
1) Once the engine has cooled, pull off spark plug
connector (9) and remove the spark plug with
supplied socket spanner. (See Fig.E1)
2) Remove debris from the electrode with a
soft wired brush; avoid heavy cleaning of the
electrode.
3) Check the spark plug gap. It should be 0.75mm.
(See Fig. E2)
4) Install the spark plug carefully by hand, to avoid
cross-threading.
5) After the spark plug is seated, tighten with
supplied spanner to compress the washer.
6) Replace with a new spark plug if either the
electrode or the insulation is damaged.
Equivalents spark plug replacement as below:
NGK BPR6ES
CHAMPION RN10Y / RN10YC / RN9Y / RN9YC / RN9YCC.
Air filter maintenance. (See Fig.F1, F2)
1) Press the latch on the cover (d) down and open the
air filter case (8).
2) Remove the filter (e) and tap it on a solid surface
to remove dust.
3) Apply a small amount of air filter oil on the filter to
increase the performance of the filter. Wring out
surplus oil and put the filter into the case.
4) Reattach the cover onto the air filter case, make
sure the latched engage properly.
WARNING: Never run the engine without the
air filter element installed.
Change the oil (See Fig. B1, G)
1) Switch engine off and still warm, disconnect the
spark plug connector (9).
2) Unscrew the dipstick (b).
3) Loosen and remove the oil drain screw (f) to empty
the oil into a suitable container.
4) Tighten the oil drain screw and refill the oil tank
with SAE30 engine oil.
5) Start the engine and allow it run briefly. Stop the
engine, wait one minute and check the oil level.
Top up if necessary.
STORAGE
1. Store the product and its accessories in a dry,
frost-free place.
2. Always store the product in a place that is
inaccessible to children. The ideal storage
temperature is between 10°C and 30°C.
3. We recommend using the original package for
storage or covering the product with a suitable
cloth or enclosure to protect it against dust.
4. Drain remaining water at the end of the working
session.
5. Store the nozzles in the accessory holder of the
product.
6. Empty the oil and fuel tank if you are not going
to use the product for an extended period of time
(more than 30 days) and before storing it for the
winter.
TRANSPORTATION
1. Switch engine off and disconnect the spark plug
connector (9).
2. Disconnect it from the water supply.
3. Tilt the product towards you until it balances on
the wheels. Then move it by its handle.
4. Protect the product from any heavy impact
or strong vibrations which may occur during
transportation in vehicles.
5. Secure the product to prevent it from slipping or
falling over, loss of fuel, damage and injury.