12
18V CORDLESS ANGLE GRINDER
EN
TECHNICAL DATA
CHARGING PROCEDURE
NOTE:
Before using the tool, read the instruction
book carefully.
Intended Use
The machine is intended for driving in and
loosening screws as well as for drilling in wood,
metal, and plastic.
1. CHARGING YOUR BATTERY PACK
a) CHARGING THE BATTERY
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use another
battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the machine
is switched off by means of a protective circuit: The
tool holder no longer rotates.
In a warm environment or after heavy use, the battery
pack may become too hot. Allow time for the battery
to cool down before recharging.
b) IMPORTANT NOTES FOR CHARGING THE BATTERY
The battery in your new tool is not charged when it
leaves the plant. Therefore it must be charged before
using the first time!
NOTE:
If the battery pack is very hot you must remove
your battery pack from the charger and allow your
battery pack to cool first to ambient temperature and
then recharging can be started.
To prevent damage to the Battery Pack, when charge
runs out, please charge the battery to reach full or no
less than half charge before storage.
If the tool will not be used for long periods of time,
charge the battery every 3-6 months.
2. HOW TO CHARGE YOUR BATTERY (See Fig. A1, A2)
Connect the battery charger to the power supply, and
then plug the DC socket of charger in to charger base
,and the light is green. Then slide the battery pack into
the charger base to make the connections. And the
green light will turn red to show charging has started.
After charging approx 3-5 hours the red light will turn
green which means the battery is full, and charging is
completed. Then slide the battery from your charger.
NOTE: This charger is designed to detect some
problems that can arise with battery pack. (see
table below)
Light
Status
Measure
Green ON
Charger is plugged
into the socket without
the battery inserted.
Red ON
Charging
________
Red OFF
Green ON
Fully charged
Red OFF
Green ON
Charging battery
too hot
Let the hot battery
cool down for a
while.
Red OFF
Green ON
Defective battery
Change a new
battery.
3. TO REMOVE OR INSTALL THE BATTERY PACK (See Fig. B,C)
Depress the battery pack release button to release
and slide the battery pack out from your tool. After
recharge, slide it back into your tool. A simple push
and slight pressure will be sufficient.
OPERATING INSTRUCTIONS
1. SLIDE ON/OFF SWITCH (See Fig. D)
To start the power tool, first press the back of on/off
switch, then push the on/off switch (3) forward.
To lock the on/off switch (3), press the on/off switch
(3) down at the front until it engages.
To switch off the power tool, briefly press down the
back of the on/off switch (3) and then release it.
2. HAND GRIP AREAS
Always hold your angle grinder firmly with both hands
when operating.
3. ADJUSTABLE AUXILIARY HANDLE (See Fig. E)
You have the option of two working positions to
provide the safest and most comfortable control of your
angle grinder. The handle can be screwed clockwise
into either hole on the sides of the gear case.
Battery voltage
No load speed
Disc size
Charger voltage
Charging time
Battery capacity
Disk bore
Spindle thread
Charger protection class
Machine weight
18V
7000/min
115mm
100-240V~ 50-60Hz
3-5 hours
1.3Ah Li-Ion
22.2mm
M14
/II
1.82kg
