Rockwell RG8259.9, Manual

Page: 12 / 16

12
18V POLE HEDGE TRIMMER EN
Fuse(For charger RW9897
Positive terminal
Read the operator’s manual.
RCM marking
Negative terminal
TECHNICAL DATA
RG8259.9
Rated Voltage 18V
No load speed 2800 /min
Max. cutting diameter 16 mm
Cutting length 450 mm
Machine weight 3 kg
Battery capacity
RW9894
2.0 Ah Li-ion
Battery capacity
RW9906
4.0 Ah Li-ion
Charger Input
RW9897
100-240V~50/60Hz, 70W
Charger Output
RW9897
20V 2500mA
The accessories of battery charger RW9897 and
battery pack RW9894 RW9906 illustrated or
described are not included in RG8259.9 delivery.
ACCESSORIES
Blade Sheath 1
Shoulder strap 1
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.ASSEMBLY
ckwise. (See Fig. D)
OPERATION
NOTE: BEFORE USING THE TOOL, READ THE
INSTRUCTION BOOK CAREFULLY.
Intended Use
The product is intended for trimming hedges,
bushes and shrubs. Observe the technical data for
the maximum cutting capacity. Do not cut branches
exceeding the stated maximum capacity.
This product is intended for private domestic use only,
not for any commercial trade use. It must not be used
for any purposes other than those described.
ASSEMBLY
Preparing To Assemble The Pole Hedge Trimmer
Always take care when removing the
packaging to prevent damage to you or to
the pole hedge trimmer.
IMPORTANT! Before assembling the pole
hedge trimmer, check all the parts indicated
in the manual are in the box. Inspect all the parts for
signs of damage. Do not assemble the pole hedge
trimmer if you observe any damaged components.
NOTE: Before using the tool, read the
instruction book carefully.
Remove all parts of the pole hedge trimmer from the
box and carefully remove all packaging. Take care not
to lose any instructions which may be attached to the
tool, these provide important information which will be
required while assembling the pole hedge trimmer.
TO ASSEMBLE THE POLE (See Fig. A1-A6)
1. Loosen the clamp knob (5) by turning anti-
clockwise. Extend the pole to expose the two
small cylinders (a). Turn the clamp knob (5) in a
clockwise direction to lock the pole to avoid pole
movement while assembling.
T 3.15A