Rockwell RD3175, Quick Start Manual

Page: 6 / 8

6
600W IMPACT DRILL EN
SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Wear ear protection
Wear eye protection
Wear dust mask
Double insulation
Warning
RCM marking
ABN: Australian Business Number. By this number,
business information such as entity type, status,
business location etc. can be found at website http://
abr.business.gov.au.
ABN of Positec Australia Pty Ltd is 14 101 682 357
TECHNICAL DATA
Rated voltage 230-240V~50Hz
Rated power 600 W
No load speed 0-3000 /min
Impact rate 0-48000 /min
Chuck size 13 mm
Drilling capacity max
Masonry
10 mm
Wood 25 mm
Steel 8 mm
Protection class:
/II
Weight 1.59 kg
OPERATION INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Intended Use
The machine is intended for impact drilling in brick,
concrete and stone as well as for drilling in wood, metal
and plastic.
1. INSTALLING THE AUXILIARY HANDLE (SEE FIG. A)
Slide the handle onto the drill and rotate to the desired
working position. To clamp the auxiliary handle rotate the
handgrip clockwise. To loosen the auxiliary handle rotate
the handgrip anti-clockwise. Always use the auxiliary
handle.
2. INSTALLING THE DEPTH GAUGE (SEE FIG. A)
The depth gauge can be used to set a constant depth
to drill. To use the depth gauge, loosen the handle by
rotating the bottom section of handle anti-clockwise.
Insert the depth gauge through hole in handle. Slide the
depth gauge to required depth and tighten fully.
3. INSERTING A DRILL BIT INTO THE CHUCK (SEE FIG. B)
To open the chuck jaws rotate the front section of the
chuck while holding the rear section. Insert the drill bit
between the chuck jaws and rotate the front section in
the opposite direction while holding the rear section.
Ensure that the drill bit is in the center of the chuck jaws.
Finally, firmly rotate the two separate chuck sections in
opposite directions. Your drill bit is now locked in the
chuck.
Warning: Before installing any accessories,
remove plug from power supply. Do not
attempt to tighten drill bits (or any other accessory)
by gripping the front part of the chuck and turning
the tool on. Damage to the chuck and personal
injury may result.
4. OPERATING THE ON/OFF SWITCH (SEE FIG. C)
Switching On and Off
Depress the on/off switch (6) to start the tool and release
it to stop your tool.
It is also a variable speed switch that delivers higher
speed and torque with increased trigger pressure. Speed
is controlled by the amount of switch trigger depression.
Continuous use
Depress on/off switch (6) then lock-on button (5), release
on/off switch first and lock-on button second. Your
switch is now locked on for continuous use. To switch
off your tool just depress and release the on/off switch.