Rockwell Automation Allen-Bradley MobileView 2711T-VMBRACKET, User Manual

Page: 41 / 104

Rockwell Automation Publication 2711T-UM001E-EN-P - March 2019 41
Install and Operate the Junction Boxes Chapter 4
To mount the back plate of an IP65 junction box, perform the following steps.
1.
Determine where to mount the junction box.
Use the dimensions in Figure 6 or Figure 7 to decide where to locate the
junction box in a safe area that is easily accessible for a terminal operator.
Figure 7 - IP65 Junction Box Dimensions (for 2711T-JBIP65DC1 and 2711T-JBIP65DM1)
2.
Use the back plate or the supplied cutout template to mark where to drill
the four mounting holes for the junction box.
3.
With a drill and drill bit, drill the four holes.
4.
Attach the back plate to the mounting surface.
Temporarily Mount the IP65 Junction Box
Temporarily mount an IP65 junction box to its installed back plate for the
following:
• For hands-free wiring and subsequent configuring of
2711T-JBIP65DC1, the IP65 junction box with cord grips
• For Box ID configuring and brightness setting of 2711T-JBIP65DM1, the
IP65 junction box with M12 On-Machine connections
IMPORTANT The following instructions also apply to the back cover plate accessory, Cat. No.
2711T-JBBKCOVER.
IMPORTANT Take precautions so metal cuttings do not enter components already
installed in the control cabinet or in the junction box.
TIP Use four M4 bolts with a maximum bolt head diameter of 9 mm, and
with self-locking M4 nuts.
However, the fasteners depend on the material of the mounting
surface, such as the wall of a control cabinet or a machine.
132.5 mm
(5.22 in.)
140 mm (5.5 in.)
70 mm
(2.76 in.)
221.1 mm (8.7 in.)
172 mm (6.77 in.)
162.1 mm
(6.38 in.)