Rockwell Automation Allen-Bradley ControlNet 1786 Series, Installation Instructions Manual

Page: 48 / 74

Publication CNET-IN002A-EN-P - December 2001
3-12 Install a ControlNet Coax Media System
e. Clean the remaining cable parts from the strip chamber after
each use.
This procedure should appropriately strip the cable, exposing
these layers of the cable:
If stripping problems persist, the strip tool may need adjustment. Refer
to Appendix B of this manual for instructions on how to adjust the
strip tool.
7. If you are using plenum FEP cable, cut off an additional 3.1mm
(approximately 1/8”) of the outer sheath with the knife from the
toolkit
TIP
If you do not see the three distinct layers of cable or
if the outer braid has been scored or cut, snip off the
exposed end with the wire cutters and repeat the
entire cable-stripping process. It is very important
that the outer braid be intact before crimping
connector.
If you are using: Go to step:
FEP cable 7
PVC cable 8
all 4 shield layers
braid/tape/braid/tape
white foam electric
or 1st tape, if tape is
bonded
center
conductor
8.3 mm
3.7 mm
4.0 mm
20076a
PVC CL2