14
Rockwell Automation Publication 6181X-IN002D-EN-P - February 2020
Industrial Computers for Hazardous Locations
Mount the Integrated Display Computer in a Panel
Use the supplied clips to secure the integrated display computer to the panel.
Follow these steps to mount the integrated display computer in a panel.
1.
Remove power from the panel.
2.
Verify that the panel surface around the area to be cut is clean and free of debris.
3.
Cut an opening in the panel by using the appropriate panel cutout dimensions.
4.
Make sure that the sealing gasket is properly positioned on the computer.
This gasket forms a compression-type seal. Do not use sealing compounds.
5.
Place the computer in the panel cutout.
6.
Slide the clips into the holes on the top, bottom, and sides of the computer.
7.
Hand-tighten the clips around the bezel by following this tightening sequence.
8.
Repeat this process at least three times until the clips are hand-tight and the gasket is
compressed uniformly against the panel.
9.
Tighten the clips to a torque of 1.35 N•m (12 lb•in) by following the torque sequence,
making sure not to overtighten.
Cat. Nos.
Clips (qty.)
Cat. No.
Description
6181X-12A2SW71DC,
10
6189X-MCLPS
Replacement mounting clips (10)
6181X-12A2SWX1DC,
6181X-12P2SWX1DC
ATTENTION:
Take precautions so metal cuttings do not enter components that are already
installed in the panel to avoid personal injury or damage to the panel components.
5
4
3
6
9
1
10
8
2
7
Hand-tighten and Torque Sequence
