8
Rockwell Automation Publication 1734-IN583C-EN-P - January 2019
POINT I/O Cold Junction Compensation Wiring Base Assembly
Remove a Mounting Base
To remove a wiring base, you must remove any module installed in the base and
any installed module to the right of the base. Remove the removable terminal
block (if wired).
1.
Snap open the RTB removal handle, or remove the removable
terminal block.
2.
Squeeze the module locking mechanism and pull up to remove
the module(s).
3.
Turn the wiring base locking screw to a vertical position to unlock the
base from the DIN rail.
4.
Slide the wiring base up to release it from its mating units.
Refer to the user manual for keying information, specifications, and information
on how to configure your module.
WARNING:
For 1734-TOPS and 1734-TOP3S, to latch and unlatch the wire, insert
a bladed screwdriver (catalog number 1492-N90 – 3 mm diameter) into the
opening at approximately 97° (blade surface is parallel with top surface of the
opening) and press in (do not push up or down).
97°
