5
1. Input Equalizer control: 3-band equalizer that adjusts high, mid, and low frequencies.
High:
12KHz ±15dB
Mid:
2.5KHz ±15dB
Bass:
80Hz ±15dB
2. Monitor control: controls the amount of signal sent to the MONITOR bus.
3. Effect control: controls the amount of signal sent to the EFFECT bus.
4. Pan control: determines the position of the channel signal within the stereo image. It features a constant-power characteristic, which means
the signal is always maintained at a constant level, irrespective of position in the stereo panorama.
5. Level control: controls the volume and adjusts the output level.
6. Clip LED: indicates that the input signal is too high.
7. PAD switch (Ch1 – Ch6): attenuates the input signal by 20dB. Use this feature when connecting a line level device or if the Mic input is distorted.
8. Line/High impedance ¼
˝
balanced (TRS) inputs (Ch1 – Ch6): This input may be used as either a high-impedance microphone input or for
line-level devices such as a cassette player, CD player, video projector or laptop. Will also allow connection from an electric guitar, bass
or keyboard. It is a two-conductor input with an impedance of 10K ohms.
9. Microphone/Low impedance XLR input: connect balanced low impedance microphones with an input impedance of 1K ohms.
PIN 1
= shield,
PIN 2
= positive (hot),
PIN 3
= negative (cold)
10. Stereo Channel input (Ch7/8 & Ch9/10): These are stereo inputs featuring a balanced XLR input and L/R ¼
˝
unbalanced (TS) inputs.
When the Left ¼
˝
jack is used alone, the signal input is mono.
11. Channel 11/12: These controls are used to adjust the signal from the CD/TAPE line level inputs or the MP3 player input. To switch
between the two, use the CD TAPE/MP3 switch (see item 16).
12. Aux in: controls volume of Aux line input as well as MP3 input (USB/SD).
13. Aux input (Ch11/12): These are stereo inputs for connecting MP3 player or any other line level input. It features L /R ¼
˝
balanced (TRS)
inputs as well as L/R RCA mono inputs. When the Left ¼
˝
jack is used alone, the input signal is mono.
14. Rec output: L/R RCA output to Tape or CD recorder (–10dB output level).
15. CD TAPE/MP3 button: switches Ch11/12 input signal between MP3 (USB/SD) and line level inputs.
16. Digital Stereo Effects display: shows the current digital effect.
17. Program control: this control allows you to select anyone of the 16 preprogrammed Digital Stereo Effects. These effects are designed
to be added to dry signals. If you move the FX to MAIN control, you mix the channel signal (dry) and the effects signal. This also goes
for mixing the effects signals with the monitor mix. The main difference is that the mix ratio is adjusted using the FX to MON control.
18. Monitor control: controls the effectiveness of the digital effects monitoring channel.
Summary of Contents for RPM109
Page 1: ......
Page 2: ......
Page 3: ......
