FOOTSWITCH Input RFS1
Using a ROCKTRON RFS1 footswitch (sold separately) you can control your channel switching via a
footswitch allowing you to switch between the CLEAN and DISTORTION channels.
LINE OUT - Output Jacks - Right & Left
These 1/4” output jacks provide a line level signal. This can allow you to plug into a recording device,
power amplifier, speaker simulator, PA system, etc. The line output is not controlled by the master volume
control. Please follow all manufacturer’s instructions when plugging this product into any outboard device.
POWER CORD PLUG
Using the supplied detachable power cord, plug the amplifier into any standard wall outlet. Please be sure
to check your local wiring and voltage to make sure your amplifier is the proper voltage for your area of the
world. Please follow all the precaution guidelines found in the front of this manual. When replacing the fuse,
please be sure to replace the fuse with the specific fuse as stated on the chassis next to the power cord plug.
A description on how to change the fuse is covered later in this manual.
HEADPHONE jack
Plugging your headphones into this jack disconnects the sound going to the speakers and allows you
to practice in private.
POWER switch
Turns the amp ON and OFF. When the LED is lit, the amp is on.
19
BACK PANEL DESCRIPTIONS
20
21
* Rocktron Rampage single (RFS1) and double (RFS2) footswitches are available and sold
separately.
SPEAKER OUTPUT Jacks - Right & Left
Used to connect additional speaker cabinets if desired. The V50D will drive a 4x12 and sounds awesome.
Connect only one additional 8 ohm cabinet per jack. Do not connect more than one per jack or you will
damage your amp!
22
23
FOOTSWITCH Jacks
FOOTSWITCH Input RFS2
Using a ROCKTRON RFS2 footswitch and a stereo cord (both sold separately) you can turn both the
CHORUS and DELAY effects ON and OFF.
24
25
FRONT PANEL DESCRIPTIONS continued...
