6
*electronic brakes *
(if provided)
Icon
Function
Icon
Function
Automatic brake switch / can be
used to load and unload tires
Looking for imbalances
4. Indication and use of wheel balancer
4.1
．
DYN (Standard/Default) mode
4.1.1. Clean wheel, take off counterweights, check pressure of wheel.Choose the way of installation according to the
type of wheel.
Main shaft-wheel— Main shaft-suitable cone(big head towards inside)
suitable cone( small head towards inside)—quick handle nut —wheel—quick handle nut
Attention
：
May add a wheel, and hold the wheel to help install the thread hub. When installing or taking off
wheel, do not let wheel move on the shaft, to avoid scratching shaft
.
4.1.2. Turn on machine
4.1.3. Input a b d value
Turn on machine, choose right way to install wheel according to the type of wheel. Set “a” “b” “d”
values:
⚫
Set “a” value
：
move the gauge to measuring position as illustrated as Fig.1, hold the gauge still in
position for approx. 4 seconds, successful memorization is given, then return the gauge to
position 0.(The value measured in automatic mode appear on the display). Or press
and
and
to change.
● Set “b” value
：
set nominal diameter “b” marked on the wheel or use the width gauge to measure the
value of ”b” as Fig.2a, then press
and
and
to change
.
If you have the
radar width gauge (optional), put down the safe guard, as figure 2b, the width value will be input automatically
⚫
Set “d” value
：
this value measured in automatic mode same time as “a” value setting, or press
and
and
to change.
