5
Right Hub Assembly
1. Working from the inside face of the Right Hub (6), fit the
Internal Flange Pivot (7) through the center hole and attach,
using three 1/4"-20 x 7/8" Flat-Head Screws (8) and 1/4"-20
Lock Nuts (5).
2. From the other side of the Right Hub (6), slide the Right-Hand
Swivel (9) onto the Internal Flange Pivot (7) until the narrow
end of the Right-Hand Swivel (9) piece seats in the hole in the
center of the Right Hub (6).
3. Fit the Right-Hand Clamp (12) onto the outside face of the
Right Side Plate (3), using the center and fastener holes as
a guide, and attach the clamp, using two 1/4"-20 x 3/4"
Flat-Head Screws (10) and 1/4"-20 Lock Nuts (5). Thread the
Four-Star Knob (11) into the Right-Hand Clamp (12), but
don’t tighten.
4. Position the Right Hub assembly on the inside of the Right
Side Plate (3) so the Right-Hand Swivel is against the Right
Side Plate and the Internal Flange Pivot (7) fits into the center
hole and through the opening in the Right-Hand Clamp (12).
Tighten the Four-Star Knob (11) to hold the assembly
together (but don’t overtighten).
5. From the inside of the Right Hub (6), insert the 5/16"-18 x 4
1
⁄
4
"
Hex Bolt (13)through the Internal Flange Pivot (7). Thread the
Handle (14) onto the hex bolt and secure with the 5/16"-18
Lock Nut (15).
Right Hub Assembly - Shown without Base Plate (2) and Left Hub/Side Assembly (1) attached for clarity
13
8
8
7
6
5
9
3
11
12
14
15
5
10
Quantity
13 5/16"-18 x 4
1
⁄
4
" Hex Bolt
1
14 Handle
1
15 5/16-18 Lock Nut
1
16 Center Hub
1
17 Washer
14
18 Hose Retaining Strap
1
Quantity
19 #8-32 x 5/8" Panhead Screw
1
20 #8-32 Lock Nut
1
21 3/8" x 2" Lag Screw
4
22 3/8" Washer
4
PARTS LIST
