7
IDENTIFICATION OF
ASSEMBLED PRODUCT
57033 WIRELESS SPEAKER KIT
FCC ID: FFDD
APPLICABLE
COMPLIANCE STATEMENTS
NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
— Reorient or relocate the
receiving antenna.
— Increase the separation between
the equipment and receiver.
— Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
— Consult the dealer or an experienced
radio/TV technician for help
RESPONSIBLE
PARTY / MANUFACTURER
ROCKLER COMPANIES
ADDRESS 4365 WILLOW DRIVE, MEDINA,
MN 55340
TELEPHONE 1-800-279-4441
WWW.ROCKLER.COM
BLUETOOTH
®
Version
5.0
BLUETOOTH
®
Profile
A2DP, AVRCP, HFP, HSP
Transducer
1 x 40mm
Output Power
3W
Frequency
Response
180Hz-20khz
Signal-to-Noise
Ratio
80dB
Battery
Charge Time
1hr
Battery
Play Time
3-4 hours 70% volume
Battery
Capacity
500mAh
Weight
78g
BLUETOOTH
®
Transmitter
Power
4dBm
BLUETOOTH
®
Transmitter
Frequency
Range
2.402-2.480GHz
BLUETOOTH
®
Transmitter
Modulation
GFSK,PI/4DQPSK
Power Supply
DC 3.7V by battery
or DC 5V by adapter
Audio Input
AUX
Charging Type
Micro USB
Changes or
modifications to this unit not expressly
approved by the party responsible
for compliance could void the user’s
authority to operate the equipment.
“This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.”
