SAFETY WARNING & PRECAUTIONS
Page 1
Read the entire technical and safety information in this manual before set up or use of this
winch. Observe safety precautions for personal safety and the safety of others. The
instructions that follow are basic guidelines only and can not cover all situations
encountered during use. The operator and assistants must carefully plan usage to prevent
accidents
.
1. Do not operate winch under influence of drugs or alcohol.
2. Read manual before using this winch.
3. Always use heavy gloves when handling wire rope.
4. Never hook the cable back upon itself. The cable can break under tension and cause injury and
damage.
5. Stay clear of wire rope and keep others away when in operation or with load on wire.
6. Inspect winch and wire rope before each use. Do not use winch if wire rope or winch shows wear or
damage.
7. Replace any parts as needed before using the winch.
8. Do not exceed the winch capacity.
9. Do not use the winch as a hoist or to move people.
10. Do not use winch to secure a load or tow vehicles.
11. This winch is designed for intermittent use only.
12. Look to see where the frill bit will come through before drilling holes for installation.
13. Never drill into the gas tank or electrical wiring.
14. Place towel or sandbag over wire while winch is in use. Fig.1
15. Keep hands clear of wire rope, hook and fairlead opening during operation. Fig.2
Always use handsaving belt to hold hook when spooling.Fig.3
Fig.1
Fig.2
Fig.3
INSTALLATION INSTRUCTIONS
When installing a winch, your installation may vary from the manual diagrams and
instructions included here due to vehicle and mounting operation in the structure. Always
disconnect the battery from the vehicle to remove the electric hazard.
CAUTION:
If you choose not to use an ATV mounting kit, You may be required to drill holes in a structural
support on the ATV. Be sure the location will be strong enough to support the rated pulling force of the
winch. Do not drill into wiring or gas tank! If the mounting bolts needed are different in length from that
supplied, use a bolt of equal or better quality to that supplied by the manufacturer. Tight the mounting
bolts to required torque.
1. Install the mounting kits or prepare a flat and secure location on the vehicle for the winch.
2. Position teh winch over the mount and check for operation of the clutch lever to frame clearance.
Check for tire to winch clearance. If ok, continue on to the next step.
3. Secure the winch to the mounting bracket or surface chosen with the correct hardware.
NOTE:
Make sure the winch mounting bolts and winch hardware have been checked for proper torque.
