12
If the White & Red lights flash and the pedaler doesn’t stop,
resistence will decrease suddenly. This can cause the pedaler to
slip, so coach them to stop when they see flashing White & Red.
1. Connect phones and devices to the USB ports. Each port can
provide an equal amount of power.
2. Pedal!
3. Lights will begin to turn on and all USB devices will start
receiving power.
The lights to the right of the USB ports show the state of
charge in the desk and give feedback to the pedaler.
Red light: keep pedaling - charge is low
Green light: ideal range - partially charged and working
White light: slow down - desk is fully charged
Flashing White & Red: STOP PEDALING
The Green lights on the underside
of the desk will glow brighter as
the desk charges up.
CHARGING DEVICES WITH PEDAL POWER
USage tips
big tooth
small tooth
big notch
small notch
Don’t unscrew the blue strain relief.
MINI RECTIFIER CABLE
ROUND CONNECTOR
GENERATOR WHEEL
ROUND SOCKET
CONNECTED DESK
CONNECT TO
GENERATOR WHEEL
CONNECT TO
RECHARGE DESK
strain relief
thumb tab
The Mini Rectifier Cable connects the Recharge Desk to the
Generator Wheel.
HOW TO DISCONNECT THE ROUND CONNECTOR:
1.
Slide the thumb tab back toward the cable
2.
Twist the connector 1/8 of a turn counter-clockwise, then pull
1. Join the cables’ flat connectors. If they don’t snap in, flip one
side over and retry.
2. Insert the round connector into the black socket on the bottom
of the desk with a push-and-twist motion.
RECHARGE DESK CONNECTORS
assembly
Pedaling may feel tough at first, if the desk has not been used recently.
13
