1. Place the frame on its side on a soft surface such as carpet
or cardboard.
2. Using the smaller bolts and washers, connect the crossbeam
to the frame, make sure the feet are facing down and the
wheel sockets facing forward.
3. Tighten the bolts securely using the 6mm hex key.
1. Turn frame back over on to crossbeam.
2. Align the holes in the rear legs with the holes through the frame.
3. Insert the larger set of bolts, tighten each four turns to make
sure the threads are in place.
4. Firmly tighten the bolts with the 8mm hex key.
6
REAR LEGS
ASSEMBLY
CROSSBEAM
7
SEATPOST
1. Open the seatpost lever, and Insert the seatpost (a).
2. Align the seatpost groove with the machine screw on the back
of the seat tube (b).
3. Tighten the screw as much as possible with your fingers,
making sure that the screw is in the groove.
4. Finish tightening the screw with the 5mm hex key (c).
see included coaching card for seat HEIGHT tips
(
a
)
(
b
)
(
c
)
Damage can occur if not tight.
If the left pedal needs to be removed, rotate the threaded
portion counter-clockwise.
1. Identify the right side pedal by it’s sticker or stamp, then install
it into the right crank arm using the 15mm wrench.
2. Once the pedal is fully threaded into the crank arm, give it a
good, hard turn to secure.
PEDALS
assembly
