For more help and details about blender adjustment, watch
videos at: rockthebike.com/troubleshooting-tips
Don’t tighten the screws
all the way yet.
Test your handlebars by to trying to move them up/down and
left/right. If they move, realign and tighten them.
1. Unscrew and keep all four
screws in stem plate then place
the handlebars in the round hole
of the stem.
2. With the bars centered start by
tightening each bolt two turns
using the 6mm hex key.
3. Once the bolts are tight
enough to hold the handle-
bars, set the angle to be
parallel to the ground.
4. Finish by tightening all six
bolts (two stem side bolts and
four stem plate bolts) to avoid
possible injury from movement.
10
HANDLEBARS AND STEM
BLENDER BASE
1. Loosen the two wingnuts on the upper platter by one or two
turns, and turn the platter counter-clockwise so the roller is
slightly touching the tire.
4. Turn the platter until the roller is firmly against the tire, then
lock the wingnuts while keeping pressure on the roller.
assembly
assembly
2. Check your alignment to
make sure the roller is
directly over the axle.
3. If the roller is not aligned,
adjust it using the hex keys.
11
SAFETY CHECK
Look for an equal gap
on the top and bottom
part of stem. If the gap
is not equal on both
sides go back to step 2.
platter
wingnut
roller
4MM
HEX KEY
5MM
HEX KEY
