Don’t tighten the screws
all the way yet.
Test your handlebars by trying to move them up/down and
left/right. If they move, realign them and tighten the bolts.
1. Unscrew and keep all four
screws in stem plate then place
the handlebars in the round hole
of the stem.
2. With the bars centered start by
tightening each bolt two turns
using the 6mm hex key.
3. Once the bolts are tight
enough to hold the handle-
bars, adjust the bars so their
grips are parallel to the ground.
4. Finish by firmly tightening all six
bolts (two stem side bolts and
four stem plate bolts).
10
HANDLEBARS AND STEM
assembly
11
SAFETY CHECK
Look for an equal gap
on the top and bottom
part of stem. If the gap
is not equal on both
sides go back to step 2.
For more help and details about blender adjustment, watch
videos at: rockthebike.com/troubleshooting-tips
if you purchased an icycleta attachment,
refer to its assembly instructions
BLENDER BASE
1. Loosen the two wingnuts on the upper platter by one or two
turns, and turn the platter counter-clockwise so the roller is
slightly touching the tire.
4. Turn the platter until the roller is firmly against the tire, then
lock the wingnuts while keeping pressure on the roller.
assembly
2. Check your alignment to make sure
the roller is directly over the axle.
3. If the roller is not aligned, adjust it
using the hex keys.
11
platter
wingnut
roller
4MM
HEX KEY
5MM
HEX KEY
