Rock Helmets Dynamo Ansi, Instructions Manual, Page: 10 / 12

10
Maximum duration of the product under
optimal storage conditions and if not
used: 15 years.
Very frequent use or under
extreme conditions
If the product is used under extreme
conditions, very high or very low temperatures,
sea water, or if exposed to frequent blows and
shocks due to the fall of stones/ice and if it
presents many scratches, its safety features
could be reduced even after a brief period of
use so that the product should be replaced.
This helmet is designed to absorb the
energy after an impact. The absorption of
the blow occurs through the partial breaking
or damaging of the shell or the internal part
of the helmet. After a strong impact (blow,
fall of stones or ice) the helmet must be
replaced even if it does not present visible
damages. The same applies in the case of deep
scratches or if the product gets into contact
with chemicals.
Storage and transportation
Store the product in a dry and cool place,
not exposed to sunlight, chemicals and at a
temperature between 5 and 35 °C. Store the
product without exposing it to mechanical
fatigue originating from crushing, pressure
or traction. During transportation protect the
product from direct sunlight, chemicals, dirt
and mechanical damages. Use a protective
bag or special containers for safe-keeping and
transportation.
Cleaning
Clean dirty products in warm water (if needed,
also with neutral soap). Rinse thoroughly with
water. Never dry the product in a dryer or near
heaters and radiators but at room temperature.
If needed, use also available non-halogen
disinfectants.
Changes to original components
The possible change or removal of original
components of the product can limit its safety
features. It is highly recommended that no
modifications or adjustments are made to the
equipment to add further components unless
explicitly advised so by the manufacturer in
writing. Apply colours, solvents, glue or sticky
labels only if they comply with the information
provided by the manufacturer.
Warning! The products must not be
exposed to dangerous conditions and
improper treatments.
Avoid contact with corrosive or aggressive
substances (such as: acids, bases, flux for
welding, oils, detergents). Avoid exposure to
high temperatures, for instance by leaving the
helmet inside a vehicle exposed to sunlight.
Avoid contact with heat or sparks. Do not sit
on the helmet and do not compress the helmet
in a sack. Avoid contact with sharp objects.
Avoid letting the helmet fall.
Warranty
Two years against material or manufacturing
faults. Normal wear, oxidation, changes, bad
preservation and different uses are excluded
from warranty.
Organization appointed to carry out the
certification: CE: C.S.I. Spa. Milan, Italy,
n. 0497