Normal operation
Installation, use and maintenance manual – Supercromo
21
6
Figure 6.2
TM619-2 timer
1
Reviewing and setting up programs
2
Operating mode setting ON, AUTO, OFF
3
Setting current date and time
4
Setting the day of the week
5
Setting the time
6
Setting the minutes
7
Reset settings
8
ON/OFF status LED
CLOCK
TIMER
DAY
HOUR
MIN
MANUAL
2
3
4
5
6
7
8
1
6.4.2
Programmable timer installation
The installation must be carried out by a TAC in ac-
cordance with the law of the country of installation.
Make sure not to work on live components.
The programmable timer kit consists of:
▶
1 digital programmable timer
▶
1 cable kit for electrical connections
▶
1 ring nut Ø 70
▶
4 screws
6.4.2.1
Supercromo 3001
To install the programmable timer proceed as follows:
1. Remove the casing from the frame and disconnect the
casing grounding cable.
2. Unscrew the control mask and with a pincer remove
the joints from the back that secure the black cap to
the mask.
3. Connect the fast-on of the cable kit to the electrical
connections of the programmable timer as shown in
Figure 6.3
4. Disconnect cable 18 (blue) from the flue gas extractor
power supply fast-on.
5. Join cable 18 (blue) to cable 91 (blue) of the cable
kit and reconnect both to the fast-on of the flue gas
extractor.
6. Disconnect cable 2 (black) from the fan thermostat
and connect this cable to cable 92 (black) of the cable
kit and reconnect both to the fast-on of the fan ther-
mostat by running the cables under the bracket.
7. Use cable 93 (black) of the cable kit to connect the pro-
grammable timer terminals 2 and 4 to each other.
8. Remove the room thermostat, disconnect cable 7
(brown) from the fast-on of the room thermostat. Join
this cable to cable 94 (green) of the cable kit and re-
connect both to the fast-on of the room thermostat by
running the cables under the bracket.
9. Reassemble the room thermostat.
10. Attach the programmable timer to the support brack-
et using the supplied screws.
11. Replace the command mask.
12. Connect the grounding cable of the casing and reas-
semble the casing.
It is necessary to set the manual/programmed
button of the gas-fired convector (button E Figure
6.1
p. 20) to the desired function (MAN position
if you want the appliance to be controlled only by
the room thermostat, AUTO position if you want
the appliance to be controlled also by the pro-
grammable timer).
Figure 6.3
Electrical connection for model 3001
1
Cable 91 (blue)
2
Cable 92 (black)
3
No connection
4
Cable 93 (black)
5
Cable 94 (green)
1
2
3
4
5
94
91
92
93
6.4.2.2
Supercromo 3002
The Supercromo 3002 is supplied as standard with the
programmable timer already fitted.
In case the programmable timer must be replaced, make
the electrical connections as shown in Figure 6.3
6.4.3
Timer programming
To reset the programmable timer press the
P
button.
6.4.3.1
Setting the date and the time
Press and hold the CLOCK button and then press the DAY
button, HOUR button, MIN button respectively to adjust
the day, hour and minutes.
The time is indicated in the 24-hour format (0:00 ...
23:59).
Summary of Contents for Supercromo
Page 27: ......
