Robur GAHP-W, Installation, Use And Maintenance Manual, Page: 15 / 68

Overview and technical specifacions
Ed. 2014-08
13
2.3 LOCATION OF THE APPLIANCE
Make sure the GAHP heat pump does not have any transport damage. Check:
- the packaging
- the unit panels
Immediately upon delivery advise the carrier of any shortages or damage.
Packing items (plastic bags, polystyrene foam, nails, etc.) must be kept out of the
reach of children, as they are potentially dangerous.
Before installing the appliance, carefully read the “Warning” information on page 3.
The unit is designed for indoor use only .
The unit must not be installed outdoors. The unit must not be exposed to rain.
The unit must be installed in a ventilated location and in compliance with local and
national regulations.
A shut-off valve must be placed on the gas supply circuit.
Antivibration connections must be placed on the water connections to prevent
vibration transmission.
The appliance should be located to provide required clearances on all sides for
maintenance and inspection.
It should not be located in an area where leakage of any connections will result in damage
to the area adjacent to the appliance or to lower floors of the structure.
When such a location is not available, it is recommended that a suitable drain pan, be
installed under the appliance.
The appliance is design certified by CSAInternational for installation on combustible
flooring; in basements; in closets, utility rooms or alcoves
.
GAHP-W and GAHP-W LB units must never be installed on carpeting, tile or other
combustible material other than wood flooring.
DO NOT install this appliance in any location where gasoline or flammable vapors are
likely to be present.
The location for the appliance should be chosen with regard to the vent pipe lengths and
external plumbing.
The unit shall be installed such that the gas ignition system components are protected
from water during operation and service.
When vented vertically, the GAHP-W and GAHP-W LB units must be located as close as
practical to a chimney or outside wall. If the vent terminal and/or combustion air terminal
terminate through a wall, and there is potential for snow accumulation in the local area,
both terminals should be installed at an appropriate level above grade such that blockage
of the terminal from accumulated debris or precipitation is prevented.
This product must be installed and serviced by a qualified installer.