Warnings
Installation, use and maintenance manual – AD
5
III
Do not entrust children, persons with physical,
sensory or mental disabilities or persons with poor
knowledge and experience with use of the appli-
ance.
Moving parts
The appliance contains moving parts.
Do not remove guards during operation, and in
any case prior to disconnecting the power supply.
Electrocution hazard
Disconnect the electrical power supply before any
operation on appliance components.
For electrical connections exclusively use compli-
ant components and according to the specifica-
tions provided by the manufacturer.
Ensure the appliance cannot be accidentally
switched back on.
Earthing
Electrical safety depends on effective earthing sys-
tem, correctly connected to the appliance and in-
stalled according to the regulations in force.
Aggressive substances in the air
The air of the installation site must be free of any
aggressive substances or impurities that could con-
taminate the evaporative packs of the appliance.
Switching the appliance off
Except in the event of danger, do not disconnect
the power supply to switch off the appliance, but
always and exclusively act through the provided
control device.
In the event of failure
Operations on internal components and repairs
may exclusively be carried out by a TAC, using only
original parts.
In the event of failure of the appliance and/or
breakage of any component, do not attempt to
repair and/or restore and immediately contact the
TAC.
Appliance positioning
Do not install the machine in closed areas; it must
be installed outside the room to be treated, unless
by specific approval by the manufacturer.
First start-up
Do not operate the unit until the air supply duct
has been installed and connected.
Wastewater
During normal operation of the system in cooling
mode, the evaporation process produces an accu-
mulation of mineral salts and solid residues in the
waste water; this water is not potable.
Routine maintenance
Proper maintenance assures the efficiency and
good operation of the appliance over time.
Maintenance must be performed according to the
manufacturer's instructions (see Chapter 7
and in compliance with current regulations.
Enter into a maintenance contract with an author-
ised specialised firm for routine maintenance and
for servicing in case of need.
Use only original parts.
Keep the Manual
This Installation, use and maintenance manual
must always accompany the appliance and must
be handed to the new owner or installer in the
event of sale or removal.
III.2
CONFORMITY
EU directives and standards
The AD evaporative coolers comply with the essential re-
quirements of the following Directives:
▶
2014/30/EC "Electromagnetic Compatibility Directive"
as amended and added.
▶
2014/35/EC "Low Voltage Directive" as amended and
added.
▶
2006/42/EC "Machine Directive" as amended and add-
ed.
▶
327/2011/EU "Ecodesign requirements for fans" as
amended and added.
Other applicable provisions and standards
The design, installation, operation and maintenance of
the systems shall be carried out in compliance with cur-
rent applicable regulations, depending on the Country
and location, and in accordance with the manufacturer's
instructions. In particular, regulations regarding the fol-
lowing shall be complied with:
▶
Electrical systems and equipment.
▶
Any other applicable law, standard and regulation.
III.3
EXCLUSIONS OF LIABILITY AND
WARRANTY
Any contractual or extra-contractual liability of the
manufacturer for any damage caused by incorrect
installation and/or improper use and/or failure to
comply with regulations and with the manufactur-
er's directions/instructions shall be disclaimed.
In particular, the warranty on the appliance may be
