Robot Coupe Mini MP 170 V.V., Operating Instructions Manual

Page: 9 / 22

8
Removing the casing
- Check that the machine is not plugged in.
- Turn the gear box in the opposite direction to that
used when attaching it.
Fitting the whisks into the gear box
- Grasp the holder in one hand.
- With the other hand, take the first whisk and insert
the shaft into the bore of the gear box
drive shaft. Make sure the drive lugs are
properly aligned with the notches.
- As you push the whisk into the gear box drive
shaft , rotate it slightly in order to slot the drive
lugs into the notches of the drive shaft ,
thereby locking the whisk into place inside the shaft.
C
E
C
D
B A
Removing the whisks from the gear box
Pull the whisk in
direction to the arrow,
gripping the ejector
in one hand and the
holder
in the other. B
A
• WHISK FUNCTION
(Mini MP 170 Combi and Mini MP 220 Combi)
Attaching the gear box to the motor unit.
- Check that the machine is not plugged in.
- Insert the threaded part into the motor unit.
- Turn the gear box in the direction of the arrow (see
figure) until it is locked into place moderately tightly.
Removing the blade
-
Unplug the power mixer
then, hold the blades
with the provided blade-locking tool.
- Using the blade-locking tool, unscrew the drive
coupling then remove the blade for easy cleaning.
- To check that the whisk is properly fixed inside the
shaft , gently tug the metal wires.
- Repeat this procedure with the second whisk. If you
cannot push it in properly, remove it, rotate it 90°
and start again.
C
Installing the emulsifying disc
- In order to install it safely, introduce the disc into
the bell, then hold it in place using the locking tool.
- Next, turn the drive coupling with this tool until it
starts to tighten.
Removing the emulsifying disc
- The disc can be removed in exactly the same way
as the blades.
B
LADE LOCKING
B
LADE LOCKING
B
LADES WITH WATERTIGHT SEALS
B
ELL
D
RIVE COUPLING
B
LADE REMOVAL
R
EMOVAL
DIRECTION
S
OLID EMULSIFYING DISC
B
ELL
D
RIVE COUPLING
B
LADE REMOVAL
R
EMOVAL
DIRECTION
SPLASH GUARD ASSEMBLY
Cover the ring with the splash guard protection
sliding it all along the foot
in the arrow
direction, the flange must be oriented down.
To remove the splash guard protection for cleaning
follow this instruction in the reverse order.
B
1
A
Mini MP USA 18/12/06 12:56 Page 8