99
INFORMATION ABOUT THE USE
ENG
6.10. CYCLE START
1.
Make sure that the film is blocked in the clamp.
2.
Make sure that the machine is set up.
3.
Place the product to be wrapped on the infeed conveyor.
4.
Select the recipe from the control panel (see 6.3. “Description of control panel”
-
“Use of the panel”).
5.
Press the “Start”
button on the control panel to start the work cycle.
The machine will carry out the wrapping automatically.
6.
After the product has been transported onto the outfeed conveyor, pick it up.
6.11. STOP AND RESTART TYPES
During production, there can be voluntary or unforeseen conditions that will cause the machine to stop
.
The possibilities are as follows:
-
Temporary stop (voluntary);
-
Stop due to blackout;
-
Production end stop;
-
Emergency stop.
Temporary stop (voluntary)
It may occur for a short work break, a few minutes.
Press the STOP button.
Danger - warning
The machine is still in operation, just press the START button to restart it.
Stop due to blackout
In case of sudden blackout, the machine stops immediately.
The electric motors stop and the pneumatically operated components remain still in their position.
When power is back on, the machine does not continue its operating cycle but remains in the same position.
To restart operation:
1.
Press the key (A
) to synchronise the various parts (rotary ring, pressers) (see 6.9. “Machine start
-
up”
-
“Synchronisation of the rotary ring”).
2.
If necessary, remove the product to be wrapped or partially wrapped from the machine.
3.
If necessary, block the film in the clamp (see 6.9. “Machine start
-
up”
-
“Film insertion in the clamp”).
The machine is ready to start a new processing cycle.
