6. Lithium battery (LiIo/LiPo/LiHV/LiFe) program
Press Enter for 3 seconds to restore factory setting
(default).
This program aims to indicate the current software
version number and hardware ID number.
The left side of the first line shows the type of battery
you select at the users setting. The value on the left
side of second line sets a charge current and the
value on the right side of second line sets the
voltage of the battery pack. After setting the current
and voltage press
Start/Enter
key for more than 3
seconds to start the process. (Charge current:
0.1~6.0A LD60, 10.0A LD100, Voltage: 2~4S)
Use these programs only when charging a lithium battery ( Lilo/LiPo/LiHV/LiFe)
with a nominal voltage of 3.6V, 3.7V, 3.8V or 3.3V per cell, respectively. The
charge current going into the battery will vary depending on the chemistry type so
it is VERY IMPORTANT that you select the correct type for your battery. The
ending voltage of the charge is also important as it varies for all four types: 4.1V
for Lilo, 4.2V for LiPo, 4.35V for LiHV and 3.6V for LiFe. The charge current (how
many Amps you are putting into the pack) and nominal voltage (Proper voltage
for the cell count of the battery you are charging) must be correct for the battery
to be charged. To change the settings, press the
START/ENTER
key to make
the selected value blink. Using the increase and decrease buttons, set you
desired amperage, then press
START/ENTER
to save the setting. You will then
be asked to select your nominal voltage/cell count. Again, use the increase
/decrease buttons to reach your desired setting and press the
START/ENTER
button to confirm and save. When you are willing to alter the parameter value in
the program, press
Start/ Enter
key to make it blink then change the value with
INC
or
DEC
key. The value will be stored by pressing
Start/Enter
key once.
Product Version
V2.1.5 EADB8902
LiPo[0] CHARGE
2.0A 11.1V(3S)
-9-
Load Factory Set
Enter
6.1 Charging Lithium Battery
