19
19
8.
Place 4 rectangular coals onto the base coal with their
decorative faces visible. They should have the front end
touching the back of the fender or inline with it. Refer to Fig
28.
9
Place the 3 remaining rectangular coals resting in the `V’ s
just created and leaning back to rest on the rear coal. Refer
to Fig 29.
7.2 CHECK GAS PRESSURE
Remove the pressure test point screw located on the injector feed pipe just left of centre on the fire. Connect a pressure gauge, depress
the control knob and rotate to the PILOT/IGNITION position until the piezo sparks. Keep the knob depressed after the pilot has lit to
activate the FSD and then rotate the knob to the HIGH position. Check that the gas pressure is as specified in Section 1.0 Technical
Data. Turn off the fire and disconnect the pressure gauge. Replace the test point screw, relight the fire and test for gas soundness around
the sealing screw using a suitable leak detection fluid.
Fig 29.
Fig 28.
Summary of Contents for 32-170-23
Page 24: ...11 0 NOTEPAD 24 24 ...
Page 25: ...11 0 NOTEPAD 25 25 ...
