30
6.6 Tab "Service"
Adjust DMX Values
- The menu allows you to set all effects to desired positions before fine calibration of the
effects .
Calibrations
- This menu enables fine calibration of fixture effects and download default calibration values.
Calibrate Effects
- The menu allows the fine adjustment of effects.
Pan
- a pan position fine adjustment
Tilt
- a tilt position fine adjustment
Calibrate Colours
- The menu serves for adjusting of LEDs saturation to achieve colour temperature
of 5600K for white output.
Red
- a red LEDs saturation fine adjustment
Green
- a green LEDs saturation fine adjusment
Blue
- a blue LEDs saturation fine adjustment
White
- a white LEDs saturation fine adjustment
By using these items you can calibrate and adjust effects to desired positions.
Calibration of the pan/tilt via the control board
1. Disconnect DMX controller from the fixture and enter the "Calibrate Effects" menu.
2. Use the [up arrow] and [down arrow] to find "Pan" and touch it to enter the fine effect adjustment screen.
3. Set desired value and save it by touching the [confirm].
4. Repeat steps 2 and 3 for the item "Tilt".
5. After calibrating all effects, touch the [confirm] to save all adjusted values and reset the fixture.
Calibration of the colour saturations via the control board
1. Disconnect DMX controller from the fixture , open shutter and dimmer and set the Macro channel
to DMX=10 (white 5600K). Aim the light beam on the lux meter (e.g. Minolta CL-200 Chroma meter)
which is placed at min distance of 2.5 from the fixture
2. Set the menu item "Colour Calibration Mode" to On (Personality-> Colour Calibration Mode-> On).
3. Enter the menu "Calibrate Effects".
4. Use the [up arrow] and [down arrow] to find desired colour and touch it to enter the fine effect
adjustment screen.
5. By means of the Red, green, Blue and White items adjust the 5600K colour temperature as exactly as
possible (∆u´v´= 0).
7. After adjusting 5600K colour temperature, touch the [confirm] to save all adjusted values and reset
the fixture.
Note: you can also use DMX controler for both calibrations stated above, calibration protocol is the following:
Effect
Mode 1
Mode 2
Mode 3
Mode 4
Mode 5
Pan-fine movement
channel 38
channel 22
channel 16
channel 11
channel 38
Tilt - fine movement
channel 39
channel 23
channel 17
channel 12
channel 39
Red - red saturation
channel 40
channel 4
channel 8
channel 3
channel 40
Green- green saturation
channel 4
channel 5
channel 9
channel 4
channel 4
Blue - blue saturation
channel 4
channel 6
channel 0
channel 5
channel 4
White - white saturation
channel 43
channel 7
channel
channel 6
channel 43
Load Default Calibrations
- The item loads default (factory) calibration values.
Updating software
- The menu item allows you to update software in the fixture via either serial or USB port
of PC.
The following are required in order to update software:
- PC running Windows 95/98/2000/XP or Linux
- DMX Software Uploader
- Flash cable RS232/DMX No.13050624 (if you want to use a serial port of PC)
- Robe Universal Interface (if you want to use an USB port of PC)
Summary of Contents for Robin 300 LEDWash
Page 1: ... Version1 7 ...
Page 36: ...36 11 Photometric diagrams ...
Page 37: ...37 Specifications are subject to change without notice April 21 2011 ...
Page 38: ...38 ...
