Robin EH09D, Service Manual, Page: 68 / 84

- 64 -
(2) Setting the attachments
-1: Set the ratchet into the reel. (Fig. 9-5)
Fig. 9-5
THE RATCHET IS KEPT AT CLOSE-POSITION
-2: Holding the ratchet, set the ratchet-guide
subassembly. (Fig. 9-6)
Fig. 9-6
SET SCREW
RATCHET
GUIDE
FRICTION
SPRING
RATCHET GUIDE SUB-ASSEMBLY
(3) Tightening the set-screw.
-1 : Push the ratchet-guide lightly by hand so
that the ratchet guide won't move and
tighten the set-screw.
(4) Storing the spring-power.
-1 : Hold the case tight and using both hands,
wind up the reel counterclockwise 6 times.
-2 : Set the reel to keep the position, whereby
the rope hole of the reel and the rope guide
make a direct line. (Fig. 9-7)
Fig. 9-7
ABOUT 200mm
FROM THE REEL
WARNING :
The spring power is at its most when the reel is being wound. Therefore, do not abruptly
put off your hand nor loosen the pressure of Your finger unintentionally.