Robertson and caine LePard 46, Owner'S Manual

Page: 43 / 100

OWNER’S MANUAL
A1010 3 Cabin Segue 110V Original Dated Sept 2006.doc Page 43 of 59
21. AIR-CONDITIONING
The air-conditioning diagrammatic is shown on the drawing L46 STD-PA-006-0.
The air-conditioning can be run off either Shore Power or the Generator.
It is recommended that you study the Cruisair Operator’s Manual before
attempting to operate the air-conditioning system.
The air intake grills should not be blocked as this could cause damage
to the air conditioning unit.
1. Operating the Air-conditioning through the Genset
1.1 Open all Aircon seacocks
1.2 Switch Genset circuit breaker to on position
1.3 Start Genset allow to run for 2 minutes minimum.
1.4 Switch Transfer circuit breaker to on position
1.5 Switch on selected Aircon circuit breaker
NOTE: If more than one unit is required do not switch them all on at
once. The initial start up load could cause the genset to trip. Allow 1-
2 minutes between switching on each circuit breaker. This will allow
the Genset to take up the start up loading.
1.6
Select required temperature at the Control panel
2. Operating the Air-conditioning through both the Shore Power Cables
2.1 Plug in Shore power cables
2.2 Switch on Shore power circuit breaker
2.3 Open all Aircon seacocks
2.4 Switch on selected Aircon circuit breaker
2.5 Select required temperature at the Control panel
3.
Operating the Air-conditioning through Single Shore Power Cable
3.1 Plug in the Shore power cable
3.2 Switch on Shore power circuit breaker
3.3 Switch on the Transfer Circuit breaker
3.4 Open all Aircon seacocks
3.5 Switch on selected Aircon circuit breaker
3.6 Select required temperature at the Control panel