10
Pop-Up Wizard
The Wizard routine will display factory default settings. Each setting will
display for ten seconds. Use the
or
buttons to change the
setting. Settings that are not changed will operate with the values that
are displayed. To fast forward through the Wizard, press Edit Schedule.
The Wizard can be exited by pressing Start/Stop Schedule. This will
save the settings and place the thermostat into operation.
Use this chart to write down the desired settings before applying power.
Settings may vary by model.
Displayed
Details
Default Change To
SCAL
choose °F or °C
°F
_______
CLOC
choose 12 or 24 hour
12
_______
LITE
y = always on, n = off
y
_______
DIFF
differential, set between 0.5 to 3.0 °F
or 0.5 to 1.5 °C
1 °F
_______
DIF2
2nd stage differential,
added to first stage differential
2 °F
_______
DLY2
2nd stage delay, in minutes
20
_______
DLY3
3rd stage delay, in minutes
20
_______
AUTO
auto changeover enable
y
_______
DEDB
auto changeover deadband
in degrees
3 °F
_______
HI
heat setting limit in degrees
90 °F
_______
LO
cool setting limit in degrees
45 °F
_______
VAC HEAT
vacation heat setpoint in degrees
62 °F
_______
VAC COOL
vacation cool setpoint in degrees
85 °F
_______
CHECK
check filter timer in hours
n or OFF
_______
CYCL
compressor short cycle delay in minutes
5
_______
CAL
calibration offset in degrees
0
_______
After the Wizard has configured the thermostat, the settings can be
edited by pressing
and
simultaneously. This will allow you to
change settings.
Factory settings that have not been changed will use the default settings
for operation.
