5
Connect to the mains
1
Fully extend the
wire aerial
.
2
Plug the cable from the mains adaptor into the
DC input socket.
Plug
the mains adaptor into a wall socket and switch on the socket.
3
A start up screen will be displayed and a station scan will be performed.
4 When a signal has been found, the clock information will appear on
the display.
Note:
If no signals are found it may be necessary to relocate your
clock radio to a position giving better reception and carry out a scan
for new stations.
5 When your clock radio is in standby press the
Info
button to toggle
between time only or time and date.
IMPORTANT:
The mains adaptor is used as the means of connecting the
product to the mains supply. The mains socket and any multi-way mains
block used for the product must remain accessible during normal use. In
order to disconnect the product from the mains, the mains adaptor should
be removed from the mains socket outlet completely. Use only the mains
adaptor provided with the product, or a genuine replacement provided by
Roberts Radio. The use of alternative adaptors will invalidate the guarantee.
Switch on your clock radio
1
Press the
On/Off
button to switch on the clock radio. After each use
the clock radio will remember the mode used and then switch on in
that mode the next time it is used.
2 If this is the first time the radio is used a scan of the Band III DAB
channels will be carried out (depending on whether a scan was
completed in standby mode).
