13
Manual tuning - FM
1. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the clock radio.
2. Press
the
On / Standby
button to switch on your clock radio.
3. Press and release the
Band
button until the FM band is selected.
4. Press and release the
Tuning Up
or
Down
buttons to tune to a station.
The frequency will change in steps of 50kHz.
If the radio is tuned to a station of suf
fi
cient signal strength with RDS
information present, then the display may change to show the station
name.
5. When the waveband end is reached the radio will recommence tuning
from the opposite waveband end.
6. Set
the
Volume
to the desired setting.
7. To switch off your clock radio press the
On / Standby
button.
Note:
If you
fi
nd that FM reception is poor, try repositioning the wire aerial, up
or down or side to side.
If you
fi
nd that an FM broadcast has a lot of background hiss, this may
often be reduced by setting the radio into Mono reception mode for the
current FM station. Please refer to the section "Stereo / Mono setting - FM"
on page 15 for further details.
3
2,7
4
4
6
FM Mode
87.50MHz
