Roberts Gorden Corayvac CRV-B Series, Installation, Operation & Service Manual

Page: 18 / 96

CRV-S
ERIES
I
NSTALLATION
, O
PERATION AND
S
ERVICE
M
ANUAL
10 of 85
SECTION 5: MAJOR COMPONENTS
The fig u res in this section pro v ide a general o v er v ie w
of component placement in a CRV-Series system.
The location of some components s
u ch as s u pports
and co u plings is cr u cial for proper installation.
Assemble the heater components as sho w n on Page
19, Figure 19 .
Optional reflector config u rations are sho w n on Page
6, Figure 3 through Page 8, Figure 11 . Install
appropriate s u spension hard w are, beam clamps,
chain or rod at predetermined locations. Adj u stments
of chain length w ill pro v ide u niform pitch.
FIGURE 12: Major Component Descriptions - Standard Reflector
Burner
Tube
Hot rolled, heat treated or
coated al
u minized t u be
s u pplied in 10' (3 m) lengths.
45° Elbow
90° Elbow
End Vent
Couplin g Assembly
with Lock
Flex Gas Line
with shut-off cock
Combustion Chamber Tee
Standard
Reflector
(Aluminum or
Stainless Steel)
Alternate o v erlap as
sho w n on Page 27,
Section 7.3.3
. Minim u m
o v erlap is 6" (16 cm).
Standard
Reflector with Hole
(Aluminum or
Stainless Steel)
Alternate o v erlap as
sho w n on Page 27,
Section 7.3.3 . Minim u m
o v erlap is 6" (16 cm).
Tube Adapter
Cross