SS476 MP Cabinet
6
5. Surface Mount Cabinet and Light Installation
(See page 3 for Recessed Instructions.)
1. Each cabinet is shipped with an
aluminum “Z” mounting bar. Cut this
bar approximately 1” shorter than
the overall width of your cabinet/light
combination. If your combination is
larger than 45” mount more than one
piece to the wall.
2. It is strongly recommended that a
support similar to that used for a
wall mounted sink be framed in the
wall during construction as shown
in figure L. A completed three door
unit is 150 lbs empty.
3. Drill a 7/32” hole through the indent
line on the mounting bracket (See
figure L.) at the stud or furring strip
location. Use the plastic anchors
supplied if no furring strip has been
installed, making sure each cabinet
is supported by at least three anchors.
A three cabinet installation should
have 9 anchors in the mounting
bracket. Follow the Poly-set Anchor
instructions on page 7 for anchors
supplied. Be sure mounting bar is level.
(Continued on page 7.)
LOCATE BRACKET
TO CLEAR SINK
FAUCETS BY AT LEAST
ONE INCH.
MOUNTING BRACKET
#10 X 2"
SMS/WOOD SCREW
1 X 3 FURRING STRIP
BEHIND WALLBOARD
OR TILE. LOCATED
AT CENTER OF BOTTOM
EDGE OF CABINET.
Fig. L
Recessed Cabinet and Light Installation Continued
8. Install doors following the instructions supplied with
the hinge and shown in Figure E on page 3.
9. Adjust doors so that there is a gap of 1/8” between
doors. This is very important.
10. Plug the cord for the “E” option door into the outlet
shelf.
11. Install shelf clips. These clips are designed
for a tight fit. A slight twisting motion may be
necessary. Install shelves as shown on page 8
12. Check for proper operation of lights, and heater.
Refer to checklist section for help.
13. Open and close doors to check operation. On
installations of the larger cabinet in combinations
of 3 or more, the center door when open may
cause the cabinet to bow from the wall. If this
occurs install a #10 x 2” or 3” SMS/wood screw
and cap through a hole drilled at the location
shown on in figure K.
DRILL 7/32" THRU TOP
OF MIDDLE CABINET 3/4" FROM BACK AND
HINGE SIDE AS SHOWN WHEN THREE OR MORE
CABINETS ARE RECESSED.
3/4"
3/4"
Fig. K
