8
9
2) Press the Enter button once to switch to the HDCS Menu. The red Timer/Profile-LED will be lit.
3) Adjust settings 1 to 7 according to the chart below, using the Up/Down buttons and pressing the Mode button to switch between
the settings.
These settings are stored in non-volatile memory. You don‘t have to run the Profile or press the Enter button in order to „save“ the
settings. All settings can be changed as described at any time.
4) To start the Profile with the adjusted values, press the Mode button until „run“ appears on the display (Fig. 8), then press the Enter
button.
The Timer/Profile-LED flashes, indicating that the Profile is running. The green Active-LED lights as soon as the adjusted Pause (Pre-
-Runtime) has passed and level A has started.
5) To leave the HDCS menu or quit the Profile, first press the Mode button until „ESC“ appears on the display (Fig. 9). Then press the
Enter button once to return to the main menu.
6.7 Operating the internal Timer
Fig.10: Adjusting the Pause (Wait-time)
Fig.11: Adjusting the faze time
Fig.12:Adjusting the fan
Fig.13:Adjusting the pump
Fig. 14: Quit the Timer-Mode
With the internal timer, the Faze time and wait time can be adjusted in minutes (0.1 - 99), the pump and fan output can be adjusted in per cent (0
- 99).
To start the Timer-Mode, press and hold the Mode button for more than 2 seconds. The red Timer/Profile-LED ] will blink as soon as the machine has
switched to the Timer-Mode. As long as the timer is in operation, the red Timer/Profile-LED blinks.
The adjusting of the output, Faze time or wait time is the same as in the Standard-Menu. This means you have to press the Mode button repeatedly
until you reach the required function.
With the Up/Down buttons you can adjust the required functions, then press the Enter button to start the timer. Please note that P and F control Pump
and Fan, whereas P. and F. control Pause time and Faze (Fog) time (Figs. 10 - 13).
The timer cycle starts with the time shown on the display when you press the Enter button (i. e. P.xx = Starts with wait time, F.xx = Starts with Faze
time). The timer cycle will not start if you press the Enter button while the pump or fan output setting is shown on the display.
You can switch back to the Standard-Menu by pressing the Mode button for more than 2 seconds or by pressing the Mode button repeatedly until
„ESC“ shows on the display and then press the Enter button once.
Summary of Contents for Stage Faze 1500AT
Page 1: ...Version 1 1 ...
