3.6. Wireless DMX operation
The external Robe Wireless CRMX-LB100 module allows receiving wireless DMX. This device is equipped
with the Lumen Radio CRMX module and antenna for receiving DMX signal. CRMX module operates on the
2.4 GHz band.
Push in the 5-pin XLR plug (1) into 5-pin XLR sockit (4) and simultaneously locating pin (2) into hole (5) in the
fixture. In this way the wireless DMX module is connected with the fixture.
NOTE: when you disconnect the DMX wireless module from fixture, press and hold lock (5) during getting the
wireless module out.
To link the fixture with DMX transmitter.
The fixture can be only linked with the transmitter by running the link procedure at DMX transmitter .
After linking , the level of DMX signal ( 0-100 %) is displayed in the menu item “Stat“ (Special -->Vireless --
>Stat).
To unlink the fixture from DMX transmitter.
The fixture can be unlinked from receiver via the menu item “ Unlink“ (Special-->Vireless -->Unlink.).
Note:
Wireless DMX operation is implemented in the processor IC-1 (Info -->Sw Ver). Version of this processor
has to be following:
IC-1 = 2.2 and higher for RGBW version
IC-1 = 1.2 and higher for SmartWhite and Day Light version.
1 - 5-pin XLR (female)
- Locating pin
3 - Lock
Robe Wireless CRMX-LB100
Summary of Contents for Robin 100 LEDBeam Wireless DMX CRMX
