1
7.5 Stand-alone mode
Synchronous operation of multiple fixtures requires that they must be connected on a data link and one of them is
set as a master ("MASt.") and the rest as the slaves ("SLA.").Only one fixture can be set as the master.The slaves
mimic the behavior of the master.Effect actions are triggered by an internal timer of the master fixture.
Important!:
Disconect the fixtures from the DMX controller before master/slave operating ,otherwise data col
-
lisions can occur and the fixtures will not work properly!
MASt.
---
Master.
Enter this menu if you want to set the the fixture as a master.Use [UP] and [DOWN] buttons
to select desired program and press [ENTER] to confirm selection.
SLA.
---
Slave.
Enter this menu if you want to set the the fixture as a slave.
The master fixture starts simultaneous program start in the other slave fixtures.All fixtures are synchronized in
every prog.steps.The fixtures run their programs repeatedly (e.g. if master runs its program "PrG.5",all slaves
will be executed program "PrG.5" too).
7.6 Special functions
Use this menu for special services.
VErS.
---
Software Version
.Select this function to read the number of the fixture software.
tEMP.
---
Fixture temperature
.Current temperature on PCB board.
bALA.
---
Balance
.Select this function to enable (On) or disable (OFF) the white balance which is set in "White
colour balance" menu below.If this function is set OFF,REDBlinder 2•48 will use maximum values (255) of
saturation for red, green and blue channel.
C.bAL.
---
White colour balance.
Using this menu you can set white balance:
1.
Browse through the menu by pressing the [UP] and [DOWN] buttons until the display shows "
C.bAL
."
menu.Press [ENTER] button and
"rEd.b."
will appear on the display.
2
.Press [ENTER] button again and use [UP] and [DOWN] buttons to adjust the new maximum value required
for the red channel.Confirm your choice by pressing [ENTER].Use the [UP] and [Down] buttons to select next
colour.
3.
Repeat step 2 for green channel "
GrE.b.
" and for blue channel "
bLu.b
".
dM.Pr.
---
DMX presetting
.The function makes possible to select from the 4 DMX- channels settings.Use [UP]
and [DOWN] buttons to select desired channel modes
(“
Mod.1,Mod.2,Mod.3,Mod.4
”)
and press [ENTER] to
confirm.For detail description of all channels see DMX protocol.
i.bLi.
---
Initial blink
.If this function is on,Led Blinder 248 LT makes auto-calibration (All LEDs light on 100% for
a short time) after switching it on.If this function is set off,you have to set manually every colour on max.bright
-
ness after switching on the driver before starting regular operating.This action should last min. one second.
UPd.
---
Software update
- Using this function you can update software in the fixture via PC and serial link.
The following are required in order to update software:
- PC running Windows 95/98/2000/XP or Linux
- DMX Software Uploader
- Flash cable RS232/DMX (No.13050624)
Note1
:Software update should execute a qualified person.If you lack qualification, do not attempt the update
yourself and ask for help your ROBE distributor.
Note 2
:DMX address,programs and all settings will be set to their default values
To update software in the fixture:
1
.Installation of DMX Software Uploader:
