Robe Faze 1000 FT, User Manual

Page: 7 / 9

6 7
Fog machine Faze 1000 FT uses 2 channels to control both fan and fog volume. Whatever channel you se-
lect on the unit, the channel next to it will be selected automatically for fog volume control. Each channel has
a value range of 0 to 225. Timer functions such as duration and interval can be programmed using the DMX
controller or the DMX control software being used by lighting and effects operator.
If Fog volume channel has a value from 0 to 5, the fog output is OFF.
Between the values 6 to 249 the volume of fog output is regulated. With 6 being the minimum volume of fog
produced and 249 approaching the maximum. The volume output rises as the DMX value is increased.
If channel has a value from 250 to 255, the machine will operate at maximum output.
Note: In the example above, if the machine were assigned the DMX address of 124, first (fan) channel will
correspond to DMX address 124. If DMX controller is connected to the device, the function keys are disabled
and you can change DMX address only.
In general, Faze 1000 FT conform to the following performance specifications:
1. Average Operating temperature = 250°C.
2. Faze 1000 FT can maintain maximum output for 60 seconds or more.
5. Technical specifications
Power supply:
Power consumption: .......... 1000 VA
Voltage: ............................. AC 230 V, 50 Hz
Fuse: ................................. T5 A@230V
Tank capacity: 2,5 Liter
Output: 3.500 Cu.ft/Min.
Heat Up time: 12 min.
Liquid cons. rate:
45 Min/Liter (100%) 2Hrs./Liter(30%)
Dimensions:
635 x 275 x 280 mm
Weight: 20,5 kg
6. Performance Notes
It is recommended that you set the Fan output at 100% and Fog Volume output at 15-20%. With such setting,
you will have continuous output of very fine haze effect
Whenever enormous effect is required, press Manual key to emit fog at 100% output instantly.
For quiet operation, lower down Fan output as desired.
All fog machines have a recycling period after long bursts when the machine will shut itself down for a short
period in order to heat up again. During this time, no fog can be produced.
7.Configuration the pump power for local AC power.
The device pump is factory configured for 230V/50Hz.If your AC power is different,the pump power can be
configured for the local voltage using the follow procedure:
1. Press the Function Key and turn on the machine at the same time.
2. Continue to press the Function Key for about 5 sec.
3. „ROBE“ logo will appear on the display and after that message „Voltage change“
4. press the Enter Key
5. The current voltage will appear on the display.Use Up and Down Keys to choose the one you need:
110V 50-60Hz
120V 50-60Hz
220V 50-60Hz
230V 50-60Hz
240V 50Hz