Divine 160 RGBW
9
3.4 Barn door and Wire guard/anti-glare installation
Barn door
Wire guard/anti-glare
1.
Unscrew screws M3x5 (3) to remove the bottom part (2) of the barn door (wire guard/anti-glare).
2.
Place the upper part (1) of the barn door (wire guard/anti-glare) on the fixture head and secure it by means
of two screws M5x10 (4) /M5x8 for wire guard/anti-glare/ with spring washers to the two threaded holes
(A) on the back side of the fixture head.
3.
Place the bottom part (2) of the barn door (wire guard/anti-glare) on the bottom part of the fixture head
and screw it back to the upper part (1) of the barn door (wire guard/anti-glare) by means of the screws
M3x5 (3).
4.
Secure the bottom part of the barn door (wire guard/anti-glare) to the fixture head by means of two
screws M5x10 (4) /M5x8 for wire guard/anti-glare/ with spring washers to the two threaded holes (A) on
the back side of the fixture head.
3.5 DMX 512 connection
The fixture is equipped with 5-pin XLR connectors for DMX input/output. Only use a shielded twisted-pair cable
designed for RS-485 and 5-pin XLR connectors in order to connect the controller with the fixture or one fixture
with another.
Wiring of the XLR connectors:
XLR socket:
XLR plug:
To build a DMX chain
1.
Connect the DMX output of the controller directly with the DMX input of the first fixture in the DMX chain.
2.
Connect the DMX output of the first fixture in the DMX chain with the DMX input of the next fixture.
3.
Always connect the DMX output with the input of the next fixture until all fixtures are connected.
Do not overload the link. Max. 32 fixtures may be connected on a DMX link.
1
– Shield
2
- Signal (-)
3
- Signal (+)
4
– Not connected
5
– Not connected
