1
11. RDM
This fixture is ready for RDM operation.
RDM (Remote Device Management) is a bi-directional communications protocol
for use in DMX512 control systems, it is the new open standard for
DMX512 device configuration and status monitoring.
The RDM protocol allows data packets to be inserted into a DMX512 data stream without adversely affecting existing
non-RDM equipment. By using a special „Start Code,“ and by complying with the timing specifications for DMX512, the
RDM protocol allows a console or dedicated RDM controller to send commands to and receive messages from specific
moving lights.
RDM allows explicit commands to be sent to a device and responses to be received from it.
The list of commands for ColorWash 00 AT is the following.
Parameter ID
Discovery command
SET command
GET command
DISC_UNIQUE_BRANCH
*
DISC_MUTE
*
DISC_UN_MUTE
*
DEVICE_INFO
*
SUPPORTED_PARAMETERS
*
SOFTWARE_VERSION_LABEL
*
DMX_START_ADDRESS
*
*
IDENTIFY_DEVICE
*
*
DEVICE_MODEL_DESCRIPTION
*
MANUFACTURER_LABEL
*
DEVICE_LABEL
*
*
SENSOR_DEFINITION
*
SENSOR_VALUE
*
DISPLAY_INVERT
*
*
DISPLAY_LEVEL
*
*
PAN_INVERT
*
*
TILT_INVERT
*
*
DEVICE_RESET
*
DMX_PERSONALITY
*
*
DMX_PERSONALITY_DESCRIPTION
*
STATUS_MESSAGES
*
STATUS_ID_DESCRIPTION
*
LAMP_STATE
*
*
LAMP_ON_MODE
1
*
*
DEVICE_HOURS
2
*
LAMP_HOURS
2
*
LAMP_STRIKES
2
*
1
...Another options for this command (only for Robe´s fixtures):
value PARAMETER_DATA=0x - lamp OFF by DMX value on DMX channel
value PARAMETER_DATA=0x - lamp OFF if DMX is not present
2
...Commands relative resetable values
12. Error and information messages
Occured errors during fixture operation are signaled by warning icon on the display:
Press [ESC] to see the current error messages. Description of error messages:
