2
10. Power down mode
This mode omits fixture reset after switching the fixture on and reduces motor powers of the fixture.
Press and hold [ENTER] and at the same time switch on the Power switch.The following message appears:
Realy Skip Initial Reset?
Escape/Enter
Press [ENTER] to activate “Power down mode” without fixture reset.Now you can set features and behaviour of the fixture
by using “Fixture Address”menu and “Personality” menu.It is expected,that this mode will be exited by switching the fixture
off ,but if you want to go directly to the “normal operation mode”,execute any fixture reset.
Note:
All motors in “Power down mode” are deactivated and switching the lamp on from the control panel is blocked.
11. RDM
This fixture supports an RDM operation. The RDM (Remote Device Management) is a bi-directional communications protocol
for use in DMX512 control systems, it is the new open standard for DMX512 device configuration and status monitoring.
The RDM protocol allows data packets to be inserted into a DMX512 data stream without adversely affecting existing
non-RDM equipment. By using a special „Start Code,“ and by complying with the timing specifications for DMX512, the
RDM protocol allows a console or dedicated RDM controller to send commands to and receive messages from specific
moving lights.
The ROBE Universal Interface with an additional ROBE RDM-network software provides the RDM functionality.
The list of RDM commands for ColorSpot 1200E AT is the following:
Parameter ID
Discovery command
SET command
GET command
DISC_UNIQUE_BRANCH
*
DISC_MUTE
*
DISC_UN_MUTE
*
DEVICE_INFO
*
SUPPORTED_PARAMETERS
*
SOFTWARE_VERSION_LABEL
*
DMX_START_ADDRESS
*
*
IDENTIFY_DEVICE
*
*
DEVICE_MODEL_DESCRIPTION
*
MANUFACTURER_LABEL
*
DEVICE_LABEL
*
*
SENSOR_DEFINITION
*
SENSOR_VALUE
*
DISPLAY_INVERT
*
*
DISPLAY_LEVEL
*
*
PAN_INVERT
*
*
TILT_INVERT
*
*
DEVICE_RESET
*
DMX_PERSONALITY
*
*
DMX_PERSONALITY_DESCRIPTION
*
STATUS_MESSAGES
*
STATUS_ID_DESCRIPTION
*
LAMP_STATE
*
*
LAMP_ON_MODE
1
*
*
DEVICE_HOURS
2
*
LAMP_HOURS
2
*
LAMP_STRIKES
2
*
1
...Another options for this command (only for Robe´s fixtures):
value PARAMETER_DATA=0x84 - lamp OFF by DMX value on DMX channel
value PARAMETER_DATA=0x88 - lamp OFF if DMX is not present
2
...Commands relative resetable values
