3
DIP 10 - if switched to ON=test light (the fixture lights at 3200K)
DIP 11 - has to be switched to OFF position to receive DMX 512 or DALI
DIP 12 - change from OFF to ON position switches the fixture to the update mode.
DMX control
The DMX start address, is the first channel used to receive instructions from the DMX controller. The address
may be any channel from 1 to 510. DMX address can be set either by DIP switch or by RDM. DMX address
set by RDM overwrites address set by DIP switch and vice versa.
DIP 11 has to be set in OFF position. DALI commands have priority to DMX operation.
Example of DMX addresses:
DALI control
Addressing of the fixture is made by means of an external DALI controller. The external DALI controller has to
send activating command (1=ON) to start control of the fixture (and deactivating command (0=OFF) to stop
control of the fixture).
DIP 11 has to be set in OFF position. DALI commands have priority to DMX operation.
4.RDM
This fixture supports RDM operation. RDM (Remote Device Management) is a bi-directional communication
protocol for use in DMX512 control systems, it is the new open standard for DMX512 device configuration and
status monitoring.
RDM allows you to set DMX address and readout software version of the fixture.
5
.
Anti-glare ring
installation
Insert the anti-glare ring (1) into the fixture until three locks (2) snap into slots (3).
