12
13
projector. If you lack these qualifications, do not attempt the installation yourself, but instead use a professional structural
rigger. Improper installation can result in bodily injury and or damage to property.
The fixture has to be installed out of the reach of people.
If the fixture shall be lowered from the ceiling or high joists, professional trussing systems have to be used. The fixture
must never be fixed swinging freely in the room.
Caution:
Fixtures may cause severe injuries when crashing down! If you have doubts concerning the safety of a possible
installation, do not install the fixture!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the fixture’s weight.
Danger of fire!
When installing the device, make sure there is no highly inflamma
ble material (decoration articles, etc.) in between a distance of min. 1,2 m.
CAUTION! Use 2 appropriate clamps to rig the fixture on the truss.
Follow the instructions mentioned at the bottom of the base.
Make sure that the device is fixed properly!
Ensure that the structure (truss)
to which you are attaching the fixtures is secure.
The moving-head can be placed directly on the stage floor or rigged in any orientation on a truss without altering its ope-
ration characteristics .
The Omega holders can be placed in 4 positions on the bottom of the base. Use the clamps (not included in delivery)
with screws M12.
For overhead use, always install a safety-rope that can hold at least 10 times the weight of the fixture. You must only use
safety ropes with screw-on carabines. Pull the safety rope through the two apertures on the bottom of the base and over
the trussing system etc. Insert the end in the carabine and tighten the fixation screw.
Fixation via the omega holders
1. Bolt each clamp (1) to the omega
holder (4) with M12 bolt and lock nut
through the hole in the holder.
2. Fasten the omega holders on the
bottom of the base by inserting both
quick-lock fasteners (3) into the
holes of the base and tighten fully
clockwise.
3. Fasten the safety-rope (2) through the
two apertures on the bottom of the
base and over the trussing system.
1
- Clamp
2
- Safety-rope
3
- Quick-lock fastener
4
- Omega holder
Possible omega holder 4 positions:
When installing fixtures side-by-side, avoid illuminating one fixture with another!
DANGER TO LIFE!
Before taking into operation for the first time,
the installation has to be approved by an expert!
