10
11
Colour-wheel:
1. Gently bend out the colour module to release it
from the fixative holes and eject it from the pres-
sing snap.
2. Put the new colour module back under the pressing
snap and push it to the 3 fixative notches.
Effect-wheel:
1. Gently bend out the effect glass holder to release
it from the fixative holes and eject it from the
pressing snap.
2. Press the ends of the spring glass-lock together
with an appropriate tool and remove it. Remove
the glass and insert the new one.
3. Press the ends of the spring glass-lock together
and insert it in the front of the glass.
4. Put the glass effect holder back under the pressing
snap and push it to the 3 fixative notches.
CAUTION! The effect glass holder with the magnet must be placed in the same
glass position as it was placed before glass replacement!
5.6 Rigging the fixture
DANGER TO LIFE!
Please consider the respective national norms during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the fixture has to be built and constructed in a way that it can hold 10 times the weight for 1 hour without
any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net. This secondary
safety attachment must be constructed in a way that no part of the installation can fall down if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges, under high
working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an expert before
taking into operation for the first time and after changes before taking into operation another time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an expert after
every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a skilled person
once a year.
Allow the fixture to cool for ten minutes before handling.
The projector should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to) calculating
working load limits, installation material being used, and periodic safety inspection of all installation material and the
