ROBBE Mistral 2.0, Instruction And User'S Manual

Page: 15 / 20

15
ENGLISH
Hint: A mechanically well adjusted model is
quite important. Therefore make sure that
you take your time, adjusting your model.
13
Use epoxy to glue the aluminum pressing
disk into the drill holes on the upper side of
the wing. Remove the plastic sheet before -
hand. Then use the wing screws to fix the
wing. Glue the 3mm torsional pin into the
root rib of the right part of the wing (slightly
roughen and degrease the adherend at first).
Hint: The wing connector can also be glued
into this part of the wing. This way you can
prevent the loss or neglect of the connector
even though the pack size increases slightly.
14
After all electrical adjustments are finished
and the rods are finely adjusted; use UHU-
Por to glue the servo opening covers and rod
covers.
16
Use epoxy to glue both 3mm torsional pins
into the front drill holes of the wings (slightly
roughen and degrease the adherend at first).
15